Enmet ISA-44-RAL-OD Uživatelský manuál stáhnout pdf (Strana 11)

ISA-44RAL-OD / ISA-44RAH-OD ENMET Corporation

3.2.1 CO Circuit

Refer to Figure 2

PURGE ADJUST

POTENTIOMETER

Adjusts purge voltage. Operation switch must be in purge position to adjust

purge voltage.

HEATER ADJUST

POTENTIOMETER

For adjusting the MOS sensor heater operating voltage. DO NOT adjust this

potentiometer unless a voltage reading indicates that an adjustment is necessary.

(May need adjusting after replacing sensor cable assembly). Voltage: .86 Vdc

+ .03 Vdc

METER ADJUST

POTENTIOMETER

To adjust and set the meter for appropriate gas response during calibration.

LOW LEVEL ALARM SET

ADJUST POTENTIOMETER

For adjusting the trip level of the CO low level alarm light.

HIGH LEVEL ALARM SET

ADJUST POTENTIOMETER

For adjusting the trip level of the CO high level alarm light and the audio alarm.

3.2.2 Oxygen Circuit

Refer to Figure 2.

OXYGEN ALARM SET For adjusting the trip level of the audio alarm and the amber oxygen alarm light.

NULL ADJUST For adjusting oxygen circuit voltage during calibration.

METER FULL SCALE ADJUST For adjusting full scale meter reading during calibration.

LOW LEVEL SET For adjusting oxygen circuit voltage during calibration.

Figure 3: Relay Hook-up, Internal Power Figure 3a: Relay Hook-up, External Power

Figure 3: Relay Hook-up, Power Internal and External

Auxiliary Horn

(example)

Install a Separate

switch to silence

an Auxiliary Alarm

110 VAC

Hot

Neutral

Auxiliary Horn

(example)

Install a Separate

switch to silence

an Auxiliary Alarm

110 VAC

Outside Source

Neutral

Hot

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Enmet ISA-44-RAL-OD Uživatelský manuál Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Enmet ISA-44-RAL-OD