Enmet RECON Series Uživatelský manuál stáhnout pdf (Strana 13)

ECON

ENMET Corporation

6.0 Specifications and Troubleshooting Tips

6.1 Specifications

Electrical Power Working Voltage

3.6V

Lithium battery,1200 mAh Rechargeable

Working time continuous, non-alarm conditions

Combustible gas: Approximately 8 hours

Toxic gas: Approximately 30+ hours

Charge time 4 to 6 hours

Operation Temperature:

–20°C to +50°C

Relative Humidity

5 to 95% RH, non-condensing

Mechanical Dimensions:

2.4 x 3.9 x 1.3 inches(60 x 100 x 33 mm)

Weight:

5 oz. (140g) including battery

Ingress Protection IP 65

Approval Designed to be intrinsically safe

OTE

: All specifications stated in this manual may change without notice.

6.2 Troubleshooting Tips

ALFUNCTION

OSSIBLE

EASONS

OLUTIONS

Unable to Turn on the detector

low voltage Charge Battery

Detector Fault Contact ENMET Corporation

Circuit malfunction Contact ENMET Corporation

No reaction to the tested gas

Exhausted Sensor Replace Sensor

Circuit malfunction Contact ENMET Corporation

Inaccurate indication

Exhausted sensor Replace the sensor

Overdue Calibration Calibrate

Wrong time display

Exhausted battery Charge and reset the time

Electromagnetic disturb Reset the time

Zero calibration function failed Too much drift Calibrate or replace the sensor

7.0 Accessories Parts

Recon is supplied with a belt clip(4) and an alligator-type clip(1) with a D-ring(2). These can be attached to the instrument as

shown below.

010101Belt Clip & Alligator Type Clip Attached Alligator-Type Clip

D-Ring

Alligator-Type Clip

Belt Clip

Attached

Fastening Screw

1 2 ... 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře

Enmet RECON Series Uživatelský manuál Strana 13

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Enmet RECON Series