Enmet PPM Formaldemeter™ htV-m Uživatelský manuál stáhnout pdf (Strana 16)

Formaldemeter

htV-m

ENMET Corporation

7. MAINTAINANCE

With the exception of the battery, your PPM Formaldemeter™

htV -m

has no user serviceable components. It is important that

no attempt is made to open the instrument other than to replace the battery. Any evidence of tampering with the instrument will

invalidate the warranty.

If you find that your instrument requires service or repair, please return it to ENMET Corporation. See Section 9.0 for warranty

information and return instructions.

7.1 Cleaning the Formaldemeter™

htv-m

On no account should the Formaldemeter™

htV-m

be immersed in liquid. Any fluid entering the instrument will destroy the

sensor and the electronic circuitry.

If the instrument’s enclosure requires cleaning, it should be wiped with a damp cloth. Never use abrasive or solvent based

cleaning agents.

7.2 Storage

When not in use, your Formaldemeter™

htV-m

should be stored in the supplied carrying case in a clean, dry environment and

away from extremes of temperature.

7.3 Instrument Battery -Low battery indicator

When the battery voltage becomes too low, and the battery needs replacing the display will flash: bAt

7.4 Battery Replacement

The instrument requires a 9V PP3 type alkaline battery.

To replace the battery, simply remove the battery compartment cover at the bottom rear of the instrument by unscrewing the

two screws and place the battery in the compartment.

8.0 Replacement Part Numbers

8.1 Calibration Standard and Filter Replacements

ENMET Corporation replacement part numbers

Calibration Standard, Formaldehyde 02700-001

Filter, phenol (pack/10) 02700-002

1 2 ... 11 12 13 14 15 16 17 18 19

Žádné komentáře

Enmet PPM Formaldemeter™ htV-m Uživatelský manuál Strana 16